View single post by Chris A. Campbell
 Posted: Mon Apr 16th, 2018 03:29 pm
PMQuoteReplyFull Topic
Chris A. Campbell



Joined: Thu Mar 6th, 2014
Location: Little Rock, AR
Status: 
Offline
I had the same issue with a 11644. The dead spot would not allow to start up and required turning the blade to a spot that would allow centrifugal swith to get going. Just a hum and happened around 1 in 5 times when switched on

My issue was the sleve collar connected to housing where the switch plates engage was inwards on one side. Slightly bent it outwards by hand and that was enough to allow plate to make contact each time.