View single post by Russ Huber
 Posted: Thu Jun 14th, 2018 05:12 pm
PMQuoteReplyFull Topic
Russ Huber



Joined: Mon Nov 14th, 2005
Location: Southwest, Wisconsin USA
Status: 
Offline
Michael Rathberger wrote:

So the blade slipped over that?


Yes, without the use of the split metal clip over the end of the after factory machining and threading that had been done the play inside the blade hub would be excessive. 

The steel shaft I believe to be 5/16" diameter and my good fortune is a machinist without great effort can duplicate it as it was.  

Last edited on Thu Jun 14th, 2018 05:54 pm by Russ Huber