View single post by Greg Mauer
 Posted: Sat Jun 16th, 2018 05:51 pm
PMQuoteReplyFull Topic
Greg Mauer

Joined: Wed Jan 4th, 2012
Location: Indianapolis, Indiana USA
PDR, as I have read, usually requires access to the underside of the dent so it can be pushed back out. I suppose a smaller hole could be drilled on the inner surface of the shell to gain access and then pushed out. In some cases glue is applied to the outside of the dent and pulled out. I am not experienced with PDR, just a curious reader.

Iā€™m still curious about the dent puller so I may give it a go and let you know how it comes out.

My dents are about 1ā€ on the top and another about 1.5 - 2ā€ on the underside.  Nice, round dents with no creases.