View single post by George Durbin
 Posted: Fri Aug 10th, 2018 02:46 pm
PMQuoteReplyFull Topic
George Durbin



Joined: Fri Nov 2nd, 2012
Location:  
Status: 
Offline
David Allen wrote: Possible?

https://www.ebay.com/itm/272828083992

Thnx David!

Yes after a little modification it would work... I would need to grind off the cast mounting pads to use it... I bought a motor with those mounting pads and I am grinding them off... I am NOT modifying the Ilg in any way, just the motor... And the shaft on these are threaded 1/4-20... The old motor had a shaft with a flat to put the blades set screw into... I have a lathe guy modifying that to! When this is done it will look exactly as original...

Geo...

Last edited on Fri Aug 10th, 2018 02:50 pm by George Durbin