View single post by Charlie Forster
 Posted: Tue Dec 18th, 2018 06:50 am
PMQuoteReplyFull Topic
Charlie Forster



Joined: Sun Jul 13th, 2014
Location:  
Status: 
Offline
I think Tom Newcity has a thred that shows how to make those shoulder screws.

What size is the hole in the link a lot are 1/4  so you can get a 1/4 stainless steel standoff ( you may have seen these in old radios)  then you will need the screw to fit the oscillator wheel . cut the standoff to the length  for your link then put the screw through it and cut it so that it tightens the stand off  but short enough that you dont jam the oscillator wheel. if you cant find stainless steel regular steel will work .