View single post by Don Tener
 Posted: Sun Jun 9th, 2019 03:28 am
PMQuoteReplyFull Topic
Don Tener



Joined: Fri Dec 21st, 2012
Location: Saint Petersburg FL, Florida USA
Status: 
Offline
I am assuming that this is a stamped steel model but a pic would help. Anyway get a real sharp chisel or knife. Slowly tap the chisel or knife into the seam of the housing with a hammer going from side to side. It will slowly start to separate. when you get a big enough opening for a screwdriver to fit then start working it with that until it comes apart.