View single post by Mike Strozier
 Posted: Wed Oct 9th, 2019 08:02 pm
PMQuoteReplyFull Topic
Mike Strozier

 

Joined: Mon Sep 9th, 2019
Location:  
Status: 
Offline
Just a hard time reattaching the motor housing to the base. Darn washers go inside the unit and my fingers are way to big to try and hold them in place inside, while shoving the motor down and then running a bolt through it lol.

*edit*

Well I managed to get one of the washers in.  Couldn't fit the other.  Not exactly sure how the Manf was able to fit them in originally.  It's holding the motor upright just fine though.  Had to do some touch-up paint as it scratched the heck out of it.  I may end up putting a washer on the butterfly nut at some point if it doesn't remain sturdy enough.   I'm keeping this fan for myself, not reselling so over all I'm good with it.

Last edited on Wed Oct 9th, 2019 09:11 pm by Mike Strozier