View single post by Mike Brown
 Posted: Sun Jun 28th, 2020 11:24 pm
PMQuoteReplyFull Topic
Mike Brown

 

Joined: Fri Jun 26th, 2020
Location: Sudbury, Massachusetts USA
Status: 
Offline
I oiled the shaft through the front & rear holes and after some spinning, it eventually spun quite freely. The shaft moved in and out about 1/16 inch. I opened up the housing and there doesn't appear to be a fiber washer, except for what looks like a crumbling rubber grommet. (Left side of photo.) It fell out of the back of the motor case. Each end of the shaft has several brass washers.I've cleaned up the motor per tips on this site. Looks much better.