View single post by Malcolm MacGregor
 Posted: Tue Oct 27th, 2020 09:06 pm
PMQuoteReplyFull Topic
Malcolm MacGregor

 

Joined: Sun May 24th, 2020
Location: Florida USA
Status: 
Offline

Ok Forum Members!I thought I’d share my fix, as I didn’t get any helping suggestions. I decided not to pry from the back as the pot metal would crack. I used a. Socket and an extension to pound it off from the inside of the motor. I also had another set of helping hands. A couple of strong taps on the. Center of the rear bearing did the trick😎