View single post by Tony Peterson
 Posted: Tue Dec 14th, 2021 07:33 pm
PMQuoteReplyFull Topic
Tony Peterson

 

Joined: Wed Dec 8th, 2021
Location:  
Status: 
Offline
Thanks for the tip!  I did remove the blades when doing the initial service, and was very careful with them.  Same when reinstalling.  It does wobble a bit, but very little.  I wondered if this was due to the blades being out of balance.  Sounds like this is the case based on what you said.  It doesn't bother me, so I will probably just leave it be.  Do you know what the large "adjustment" screw is for on the side of the oscillator gearbox?  Just wonder its purpose.