AFCA Forums Home
Home Search search Menu menu Not logged in - Login | Register
AFCA Forums > Antique Fan Collectors Association > Pre-1950 (Antique) > Robbins & Myers 4212 Speed Control

 Moderated by: Steve Cunningham, Rod Rogers, Larry Hancock
New Topic Reply Printer Friendly
Robbins & Myers 4212 Speed Control  Rate Topic 
AuthorPost
 Posted: Tue Oct 9th, 2018 05:12 am
  PMQuoteReply
1st Post
Ed Thomas
AFCA Member
 

Joined: Tue Feb 28th, 2017
Location:  
Status: 
Offline
I have a Robbins & Myers 4212 that I picked up recently. The fan needed a little push with my finger to get started ... at that point the fan ran very smooth on all 3 speeds. The assumption was that the fan just needed lube. Upon taking the fan apart, I found the poecelain base for the speed control was broken in 2 places ... all the way across. Is it possible to replace the porcelain base only or the speed control as well? Either way I am looking for replacement parts if anyone out there has anything. Thanks!

Back To Top PMQuoteReply  

 Posted: Tue Oct 9th, 2018 05:57 am
  PMQuoteReply
2nd Post
Levi Mevis
AFCA Member


Joined: Tue Feb 24th, 2015
Location: Elkhart, Indiana USA
Status: 
Offline
The speed coil itself should be able to transfer to another ceramic switch base as the speed coil is just fine, its the switch base itself that will need to be replaced. 

There have been some members on here that have repaired the old broken switch base successfully using pool epoxy, get a hold of Russ Huber for the information about repairing broken switches with pool epoxy as he was the one who did that successfully and posted the results. 

As for the fan's rotor binding up when we were monkeying around with it yesterday morning, I'm pretty sure the fiber spacer washers are more than likely disintigrated and that's what's causing the rotor to bind up, like I said earlier those fiber washers can be bought from Ace Hardware for less than 50 cents a piece. 
Just measure the rotor shaft diameter and whatever the rotor shaft's diameter is, you'll want to find fiber washers with an inner diameter of that same size or slightly larger, and you'll probably need 4 of them, 2 in the front and 2 in the back, that's usually the formula for proper rotor spacing in these old fans but there are some exceptions, generally you'll want enough spacers in the fan to have 1/8" to 1/16" of front/back play in the rotor.

Back To Top PMQuoteReply

 Posted: Tue Oct 9th, 2018 12:25 pm
  PMQuoteReply
3rd Post
Chad Hunter
AFCA Member
 

Joined: Thu Oct 13th, 2011
Location: Birmingham, AL.
Status: 
Offline
Or use the search function.

https://www.afcaforum.com/view_topic.php?id=47322&forum_id=1&highlight=pool+epoxy

Back To Top PMQuoteReply  

Current time is 03:21 am  
AFCA Forums > Antique Fan Collectors Association > Pre-1950 (Antique) > Robbins & Myers 4212 Speed Control Top



Beige Theme By: Di @ UltraBB
UltraBB 1.17 Copyright © 2007-2008 Data 1 Systems
Page processed in 0.2007 seconds (39% database + 61% PHP). 28 queries executed.