AFCA Forums Home
Home Search search Menu menu Not logged in - Login | Register
AFCA Forums > Antique Fan Collectors Association > Pre-1950 (Antique) > Westinghouse 164864B gearbox removal

 Moderated by: Steve Cunningham, Stan Adams, Rod Rogers
New Topic Reply Printer Friendly
Westinghouse 164864B gearbox removal  Rate Topic 
AuthorPost
 Posted: Sun Oct 25th, 2020 09:16 pm
  PMQuoteReply
1st Post
Malcolm MacGregor
AFCA Member
 

Joined: Sun May 24th, 2020
Location: Florida USA
Status: 
Offline





I’m trying to remove the one piece gearbox. I have removed 2 screws that hold the centrifugal start4 screws that are inside the motor holding the gearbox to the steel housing. I have removed 4 screws on the bottom. I have tapped it with a rubber mallet. Using a screw driver it has moved a little on the bottom. But I’m being cautious as I don’t want to crack the gearbox assembly. Photos attached. 
Thank you  Malcolm MacGregor

Back To Top PMQuoteReply  

 Posted: Tue Oct 27th, 2020 09:06 pm
  PMQuoteReply
2nd Post
Malcolm MacGregor
AFCA Member
 

Joined: Sun May 24th, 2020
Location: Florida USA
Status: 
Offline

Ok Forum Members!I thought I’d share my fix, as I didn’t get any helping suggestions. I decided not to pry from the back as the pot metal would crack. I used a. Socket and an extension to pound it off from the inside of the motor. I also had another set of helping hands. A couple of strong taps on the. Center of the rear bearing did the trick😎

Back To Top PMQuoteReply

Current time is 11:06 am  
AFCA Forums > Antique Fan Collectors Association > Pre-1950 (Antique) > Westinghouse 164864B gearbox removal Top



Beige Theme By: Di @ UltraBB
UltraBB 1.17 Copyright © 2007-2008 Data 1 Systems
Page processed in 0.1503 seconds (19% database + 81% PHP). 27 queries executed.