Antique Fan Collectors Association



AFCA Forums > Antique Fan Collectors Association > Pre-1950 (Antique) > GE pancake casting

Moderated by: Steve Cunningham, Stan Adams, Rod Rogers

Author

Post

Phillip L Clay
AFCA Member

Joined:	Sun Jul 26th, 2020
Location:
Status:	Offline

Hi,Is this a stop boss or just a sloppy weld or casting?

Attached Image (viewed 148 times):

Geoff Dunaway
AFCA Member

Joined:	Fri Dec 23rd, 2005
Location:
Status:	Offline

Stop boss. there's a thumb screw on that side of the yoke that applies pressure against the motor housing in that curve around the motor mount hole. That keeps the motor still in the yoke at any desired position.

Phillip L Clay
AFCA Member

Joined:	Sun Jul 26th, 2020
Location:
Status:	Offline

Hi,Thanks for the information.