View single post by Chad Arrowsmith
 Posted: Sun Mar 28th, 2021 05:32 pm
PMQuoteReplyFull Topic
Chad Arrowsmith

 

Joined: Sun Mar 28th, 2021
Location: Georgia USA
Status: 
Offline
Hello everyone,
I am brand new to the forum as well as this is my first fan restoration.

When it comes to understanding the low level details of speed resistors, it is just over my head.  I have searched the forum and have found a couple of "questionable" solutions, but this is only because it is outside of my understanding.

I am hoping someone can give me advice on how to replace the bad resistor with a modern solution to make the fan reliable and safe.

3 speed, only low works.  Medium and High don't do anything.  I replaced the switch with a cheap one to verify it isn't the switch, I got the same results.

Any suggestions?  Much appreciated.