View single post by Louis Luu
 Posted: Mon Jun 7th, 2021 03:47 pm
PMQuoteReplyFull Topic
Louis Luu

 

Joined: Sat Oct 2nd, 2010
Location:  
Status: 
Offline
Next step.  Make sure the boss of the house is asleep and find a place to work at....pantry sink.  I use this 3M bondo to fill in the crevices that will cause casting problems...these are usually rivet/screw holes.  Let it sit in the sink for 1 hour before throwing into the oven at 200 F to fully cure for 30 minutes and let cool.  Again...make sure the boss is asleep.




Last edited on Mon Jun 7th, 2021 04:01 pm by Louis Luu